Interior and exterior escalator components

The platforms contain a floor plate provides a place for the passengers to stand moving stairs and also combplates are an entrance and exit for the passengers to provide mounting for the comb segments and comb plate switch actuator. Motors that drive the stairs, top platform contains the motor assembly and the main drive gear while the bottom holds the step return idler sprocket anchor the ends of the escalator parts truss. This plate is flush with the finished floor allow easy access to the machinery below. Moving step at the stationary floor that is the edge has a series of cleats that resemble the teeth of a comb. These teeth mesh with matching cleats on the edges of the steps is necessary to minimize the gap between the stairs which helps prevent objects from getting caught in the gap. The ends of the truss are attached to the top and bottom landing platforms via steel or concrete supports. The truss carries all the straight track sections connecting the upper and lower sections, designed to carry the entire load of the escalator parts equipment and the steel covering without shifting more than specified by the contract requirements. The entire structure is rigid enough to maintain close operating tolerances.

The guideline to track system step chain is directly pulls the steps from the bottom platform and back to the top in an endless loop, long the straight section of the truss, at the top and bottom of the escalator and the two tracks converge so that the front and back wheels of the steps are almost in a straight line. This causes the stairs to lay in a flat sheet can easily travel around the bend in the curved section of track. The tracks carry the steps down along the underside of the truss until they reach the bottom landing, where they pass through another curved section of track before exiting the bottom landing. The tracks separate then the steps assume again to a staircase configuration. This cycle is repeated continually as the steps are pulled from bottom to top and back to the bottom. Guidelines are used to track the steps wheels and step chains in their travel around the escalator truss, the curve plates at the upper and lower landing sections. They are curved at the upper and the lower end of the incline to allow smooth transition of steps from the form of stairs to a horizontal movement to contain the chains and the step rollers going around them.

The balustrade consists of the handrail deck provides a convenient handhold while they are riding the escalator at the chain that is connected to the main drive gear by a series of pulleys and the exterior supporting structure of the escalator exterior components extending above the steps and it supports the handrail designed as interior low deck or interior high. It may also refer to the individual interior panels and deck covers of the escalator. Each interior balustrade panel section is individually removable to allow easy access to the escalator interior for proper maintenance.

Escalator Parts Installation

Human beings as we are often called, can live simple but yet it is still complex. So many needs and wants we often crave for and sometimes it causes our problems. We tend to avail of the things we see in others and yet we do not use our thinking ability to ask ourselves of what do we really want in life. Sometimes we keep on wanting what we cannot afford to have because we are not thinking or we are not using our minds. We cannot even identify our needs and priorities but anyway we can learn from those individuals who can share to us their talents provided we are willing to listen and do action on what we have learned from them.

If we think it over and over again, we human beings are so lucky to be called such, why? Because we were given the chance to have total freedom to think, innovate and act on things we seem not pleasing to us, we were given the supreme intellect and the absolute will to do everything that is good and favorable for all. Using our tools; the freedom, the intellect, and the will, is much more than enough to let us survive and live our life to the fullest and enjoy. But then again we say that all the 7 billion population of the planet earth have also a seven billion unique individualities of each every human being. This tells us that when all these uniqueness are summed up together and clustered according to their talents, skills, capability and everything, the world is really a nice place to live whether we like it or not.

The seven billion population of the earth can be compared to the trillion cells of our individual body. That this single cell represents each of the different chromosomes or the DNA in the different organs of our body. This can be true also to the talents and the unique being of every human. Of course not two individuals are the same even the identical twins as they say. So that there can be a sense of strong complementation and supplementation of skills and ideas in between two or three individuals like the story of Bill and Gates.

So nice to feel good and better if the escalator being the frequented part of the building would be clean to use all the time and every time. By then the manufacturers of the said escalator with all the other escalator parts intact form a big slice of the cake because a simple to medium and high rise buildings will not exist without these building accessories with the complete parts to be installed. They must ensure that they have included in the package a simple and easy to follow instructions on how to install the escalator parts step by step, for safety, for prevention of untoward incidents that may happen to users and more. Other manufacturing companies use to include a write up of the object with complete instructions to be followed by the buyer and others support it with a video for them to listen before installation of the parts.

First Impression Last

Inside our houses equipment and appliances needs cleaning and maintenance to stay it on good shape and works properly. It adds more life to the equipment with a proper maintenance and cleaning. We all knew water, humidity, sunlight and other natural phenomenon damages electrical and mechanical equipment but the use of modern technology electrical and mechanical equipment can withstand variety of climatic conditions. This is true when you see equipment that is use in an open area. For example an escalator, there are escalators that are inside a building or underground railway systems and well protected against the wind and weather phenomenon. But there is also escalator that is completely running in open air, under the heat of the sun with any weather condition. Its components are especially made for extreme usage and weather conditions. It is necessary to check the materials use to see if they are resistant to any kind of conditions, checking if there are reaction to some chemicals, moisture and heat. As the escalator is situated outside, dirt, dust, oil and other impurities needs to be clean regularly as part of its maintenance procedures.

Escalator cleaning is a demanding job mostly carried out by specialized companies. Several cleaning system are used as well as variety of partially aggressive cleaning agents.  When you are entering a hotel or an airport or a shopping center an escalator is the first thing you will have to notice when roaming around the building. It makes a good impression when you see the escalator is well clean and taken care of, no matter how clean the other areas are, if the escalator is not clean people may have a negative impression of the facility.

There are lots of challenges to consider in doing escalator cleaning.  They require specific cleaning products and machines because escalators are not flat surfaces like floors and counter tops. The grooves or the design of the escalator steps are a magnet for impacted dirt and are hard to remove. Only professionals can do the cleaning with the use of specific chemicals and cleaning agents. If the escalator is always been use like in train station the timing of cleaning is another factor to consider, unlike for shopping malls you can re route the passenger or the flow of people to another escalator or after mall hours. Another factor is the cost ant the method of cleaning.

In doing escalator cleaning you must have a plan or schedule in cleaning your equipment. Most establishment and facilities prefer to clean and maintain their escalator during closing time. In some 24/7 establishment’s escalator cleaning is done during slack time or during the slowest traffic time. Regular cleaning and maintenance must be done regularly, because heavily soiled escalators requires more work and time of cleaning.

Selecting right equipment for escalator cleaning is the most important part of the job. Other escalator cleaning contractors suggesting to tear down the escalator bringing it out doors and uses high pressure washer to clean it, but it is rather costly and messy and the hours of cleaning are very long. You may consider another solution or method like dry cleaning; it is much safer to the escalator components and convenient also.

How do Building Personnel Clean the Escalator Steps?

The escalator is one of the first things visitors will see upon entering a hotel, airport or shopping center.  Regardless of how sanitary the other areas of an establishment are, if the escalator is not clean visitors immediately can get a bad impression of the facility.

Just like any complex piece of machinery, escalators break down and they require routine maintenance that can keep them out of service for a considerable length of time, days or a lot longer if there is an issue in getting the right replacement parts.  Escalators get dirty pretty fast. Considering hundreds or thousands of feet come and go in an escalator within the day, it is imperative to clean it every single day.  When the steps get all gritty, it is not only an unpleasant sight to view, but it diminishes the life span of the escalator and leads to more frequent malfunctioning when all that dirt builds up in the machine.  escalator step cleaning an escalator can seem like somewhat an overwhelming task to personnel like the building service contractors and in-house escalator step cleaning professionals.  However, cleaning an escalator does not have to be a hard task if there is a plan and the right equipment is utilized.  The steps are solid, one piece, die-cast aluminum or steel.  Yellow boundary lines could be added to unmistakably highlight their edges.  Consistently, escalators must be cleaned late at night after an establishment is closed and be tidy and operational when the facility reopens the next day. 

Escalators are not flat.  Some cleaning employees have tried to clean escalators by dust or moist, mopping them just like it is a flat floor.  While this may actually work to eliminate a spill or some staining, it will not work to completely clean the escalator.  Grooves on the steps of an escalator help promote safety.  Unfortunately, soil and dust are accumulated in these areas.  Similar to the sealant surrounding tile, soil and moisture can get stuck in the grooves, and the longer they stay there, in many cases, the difficult they are to remove.  The grooves can vary in size, meaning each single escalator may have its own unique cleaning tasks.  At one time, escalators were cleaned by detaching the steps, taking them off the area for pressure washing, waiting for them to dry, and then reinstalling them.  This was effective but a tedious job and expensive as a result.  Some escalators are cleaned by cleaning every single step.  This is not as effective, and it is a time-consuming process as well. 

In the present times, many cleaning professionals use what is frequently referred to as an automatic escalator cleaning system.  These are considered “hands-off” cleaning systems because everything that is necessary is appropriately installing the unit.  From there, operators of these types of cleaning machines typically do the following: Begin with the escalator turned off and connect the cleaning system at the base of the escalator.  Put a safety warning cone at the base of the escalator.  Lower the cleaning head onto the escalator and operate the escalator.  The steps should be moving away from the machine and not towards it.  The built-in vacuum of the system gathers dirt and debris on the steps, which is the first stage in the cleaning process.  Brushes and pads loosen and remove soils inserted in the steps, which are then vacuumed up.  There is no set time period to operate the machine; cleaning time is dependent on how dirty the escalator is and its length.  The final stage is to lower the buffing pads and let the machine to further remove soiling and finish the process.  Cleaning personnel should ensure they are fully aware of how escalator cleaning apparatus is positioned, operated, and maintained before starting the cleaning process to avoid injury to the personnel or to the machine itself.

Watch Those Escalator Steps

 Afraid of stepping on an escalator? It’s easy to say “Don’t be.” If a person is afraid of riding an escalator, well, he can’t be forced to do so. Some people have a phobia about this transporting machine, maybe due to an accident in the past that has traumatised them immensely. But if one wants to overcome his fear about escalators, he needs to seek a professional who will help him deal with this problem. One way to do it is practice being on an escalator with a trusted friend or relative. Be on an escalator when there are few people using it. In time with lots of encouragement, determination, practice and counselling, a person will be able to overcome his issues of using an escalator. But if riding on an escalator is too much for a person to bear at the moment then let him take his time to deal with it.  He can use a regular staircase instead or an elevator.

Stepping on the escalator may be an easy feat for you. However people using canes or walkers are advised to use elevators instead of escalators. The Escalator Step Cleaning can be fast for people who have walking problems. If you are going to use an escalator, it is better if you use a good pair of footwear. Soft shoes or slippers have a chance of getting caught on the plates of the escalators. Gaps on the steps can cause an accident and footwear entrapment can happen. Horrific situations can occur if the steps of the escalators are broken. Be alert during your ride; notice if there are broken steps that can injure people. Step on and step off the escalator on a timely manner because there is a continuous flow of people at your back. You might get bumped if you linger on the entrance and exit parts of the escalator. Try to take notice and understand the warning signs that are posted on the escalators for it may save your life or other people’s lives.

Escalator Step Cleaning can be a good site for placing ads.  There are some ad agencies that put advertisements on the steps to catch the attention of the buying public. As long as the ads are placed well and the escalators are working properly, then product placement is a good business option. Escalator steps are connected by metal chain forming a loop. The part where people step on is a step plate or thread. There are steps that have coloured demarcation lines to help warn the people the boundary of a thread. If a step is tilted or inclined while the escalator is moving, there must be something wrong with it. It should be on the right level, not tilted, to aid the user have the correct balance while riding the escalator. Steps and other parts of the escalators are connected to each other so that the escalators will move smoothly. If the steps are needed to be cleaned or repaired, then have your escalator maintenance team fix them.